Technical Specifications; Troubleshooting - Philips Lumea SC2007 Manual

English
18
Guarantee and support
If you need information or support, please visit www.philips.com/support or read the separate
worldwide guarantee leaflet.

Technical specifications

Rated voltage
Rated frequency
Rated input
Protection against electric shock
Protections rating
Operating conditions
Spectrum of precision attachment
Lithium-ion battery

Troubleshooting

Problem
The device suddenly
switches off.
The device/adapter
becomes warm during
charging
I cannot use the device
from the mains.
The 'ready to flash light'
doesn't light up when I
place the attachment on
my skin, but the cooling fan
works.
This chapter summarizes the most common problems you could encounter
with the device. If you are unable to solve the problem with the information
below, visit www.philips.com/support for a list of frequently asked questions
or contact the Consumer Care Center in your country.
Possible cause
The rechargeable batteries
are empty
This is normal.
Due to safety reasons it is not
possible to use the device
from the mains.
The overheat protections has
been activated.
100V-240V
50Hz-60Hz
7,5W
Class II
IP 30 (EN 60529)
Temperature:+15 ºC to 35º C
Relative humidity: 5% to 95%
>600nm
2 x 3.7 Volt 1500 mAh
Solution
Charge the device. See Chapter
Charging.
No action required.
Philips Lumea can only be used without
cord.
When the overheat protection has been
activated, the fan still works. Do not
switch off the device, but let it cool down
for approx.15 minutes before you
continue to use it.