Download  Print this page

Settings For The Sound (audio Setup) - Sony DVP-NCBOOH Operating Instructions Manual

Hide thumbs

Advertisement

Settings for the Sound
(AUDIO SETUP)
"AUDIO SETUP" allows you to set the sound
according to the playback and connection
conditions.
Select "AUDIO SETUP" in the Setup
Display. To use the display, see "Using the
Setup Display" (page 54).
The default settings are underlined.
• AUDIO DRC (Dynamic Range Control)
(DVDs only)
Makes the sound clear when the volume is
turned down when playing a DVD that
conforms to "AUDIO DRC."
This function affects the output from the
following jacks:
-LINE
OUT LfR (AUDIO) jacks
- DIGITAL OUT (OPTICAL or COAXIAL)!
HDMI OUT jack only when "DOLBY
DIGITAL" is set to "D-PCM" (page 60).
STANDARD
Normally, select this position.
TV MODE
Makes low sounds clear even if
you tum the volume down.
WIDE
Gives you the feeling of being
RANGE
at a live performance.
• DOWNMIX
(DVDs only)
Switches the method for mixing down to 2
channels when you playa DVD which has
rear sound elements (channels) or is recorded
in Dolby Digital format. For details on the
rear signal components, see "Checking the
audio signal format" (page 45). This function
affects the output of the following jacks:
- LINE
OUT LfR (AUDIO) jacks
- DIGITAL OUT (OPTICAL or COAXIAL)!
HDMI OUT jack when "DOLBY
DIGITAL" is set to "D-PCM" (page 60).
DOLBY
Normally, select this position.
SUR-
Multi-channel audio signals are
ROUND
output to 2 channels for enjoying
surround sounds.
NORMAL
Multi-channel audio signals are
downmixed to 2 channels for use
with your stereo.
• DIGITAL OUT
Selects if audio signals are output via the
DIGITAL OUT (OPTICAL or COAXIAL)!
HDMI OUT jack.
ON
Normally, select this position.
-
When you select "ON," see
"Setting the digital output signal"
for further settings.
OFF
The influence of the digital
circuit upon the analog circuit is
minimal.
If
you are using the
HDMI OUT jack, PCM sound
will be output depending on the
connected equipment.
If the signal is encrypted for
copyright protection purposes,
the signal is only output as
48 kHzJl6 bit PCM.
Setting the digital output signal
.Switches the method of outputting audio
signals when you connect a component such
as an audio component or MD deck with a
digital input jack.
For connection details, see page 18.
Select "DOLBY DIGITAL," "DTS," and
"48kHz/96kHz PCM" after setting
"DIGITAL OUT" to "ON."
If you connect a component that is
incompatible with the selected audio signal, a
loud noise (or no sound) may be heard from
the speakers, risking damage to your ears or
speakers.
• The A
V
SYNC function (page
36)
is not effective
if you use the DIGITAL OlIT (OPTICAL or
COAXIAL) jack, and set "DOLBY DIGITAL" or
"DTS" to "DOLBY DIGITAL" or "ON"
respectively.
• The AV SYNC function (page
36)
is not effective
if you connect a Dolby Digital or DTS-compliant
device via the HDMI OlIT jack, and set "DOLBY
DIGITAL" or "DTS" to "DOLBY DIGITAL" or
"ON" respectively.
"continued
59
US

Advertisement

Chapters

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: