Philips QT4045 User Manual page 11

Removing the battery
Do not connect the appliance to the mains again after it has been
opened.
Follow the steps below to remove the battery.
1 Disconnect the appliance from the mains and let the appliance
run until the motor stops.
2 Remove the two side panels by means of a screwdriver (fig. 14).
3 Remove the front panel by means of a screwdriver (fig. 15).
4 Pull out the printed circuit board (fig. 16).
5 Remove the rechargeable battery by means of a screwdriver and
detach it by bending or turning it several times until the
connections break (fig. 17).
Guarantee & service
If you need information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Customer Care
Centre in your country (you will find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in
your country, turn to your local Philips dealer or contact the Service
Department of Philips Domestic Appliances and Personal Care BV.
Troubleshooting
The trimmer does not work when it is switched on.
1 If the battery is completely empty, the trimmer will not work.
Charge the appliance until it is fully charged (see chapter
'Charging'). Charging will take approx. 10 hours.
If the suction system of the vacuum beard trimmer performs poorly or
does not work at all, check the points listed below.
ENGLISH
11