Indicator Names And Functions - Sony PCS-TL30 Quick Start Manual

Connector panel
(section behind rear cover, seen from
below)
1 2
a DC19.5V connector
Connect the supplied AC adapter PCS-AC19V6A or
PCGA-AC19V7 here.
b AUDIO IN (PC sound input) jack (stereo mini
jack)
Connect this jack to the audio output of a computer
connected to the RGB IN connector.
c RGB IN connector (15-pin mini D-sub connector)
Connect the RGB output of a computer here.
d 100BASE-TX/10BASE-T port (RJ-45)
Use a Category 5 LAN cable to connect this port to a hub
or similar equipment.
This port is equipped with a Link/Data indicator (green)
and a 100/10 Mbps indicator (orange).
e PC port
This connector is used when the same mouse is to be used
for the PCS-TL30 and for a computer connected to the
RGB IN connector. Link the connector to a USB port on
the computer.
Note
Do not use a USB cable that is more than 3 m (9.84 ft.) in
length.
f RS-232C port (9-pin D-sub connector)
This connector is used only for servicing the system.
g Mouse port
Connect the supplied optical mouse PCS-RMU1 here.
3 4 5 6 7

Indicator Names and Functions

Indicator Status
Lit green
(Power) *
Lit orange
Flashing orange (1-
second cycle)
Out
Online * Flashing blue
(3 times per sec.)
Blue illumination lit
Blue intermittent
flashing
Out
Lit blue
(PC) *
Lit white
Out
Lit blue
(Videocon
Lit white
ference) *
Out
Lit orange
(Mic off) *
Lit white
Out
Lit orange
("Memory
Out
Stick")
Tally lamp Lit orange
Flashing orange
(5-second cycle)
Out
Link/Data Lit green
Flashing green
Out
100/ Lit orange
10 Mbps
Out
* The indicator is lit while the system is starting up. If abnormal temperature
is detected, the indicator flashes and power turns off.
Meaning
Power is on
Standby
Problem with fan
Power is off
Sending/receiving
Communication in
progress
Missed call indication
Offline (no missed call) or
standby
Computer display
Videoconference display
Standby
Videoconference display
Computer display
Standby
Mic off
Mic on
Standby
Accessing "Memory Stick"
Not accessing "Memory
Stick"
Camera image being sent
to remote party (lens
cover open)
Closed image being sent
to remote party (lens
cover close)
Camera image not being
sent
Link is established
Data is transferring
Link is offline
100 Mbps
10 Mbps
Names and Functions of Parts
25