Watching Channels From An External Device; Access The Home Menu - Sanyo FW50C85T Owner's Manual

Watching Channels from an External
Device
Switching Each Input Mode can easily switch with the Remote Control
between TV and external devices when they are connected to the unit.
1
Turn On the Set-top Box or the Connected Device.
① Press SOURCE and use J K to Select the Set-top Box or the
Connected Device and wait a few seconds till the Picture appears.
HDMI1
Watch TV
② Use the Remote Control of the Set-top Box or the Connected Device
to Select Channels.

Access the Home menu

1
Press Z.
Guide to Home menu
Source Home Network
Watch TV
a Watch TV : Switches back to the TV Source if another
Source is selected.
b Source : To Select Connected devices.
c Home Network : Accesses Home Network Menus.
d Apps : Accesses Apps Menus.
e Miracast : Accesses Miracast Menus.
f Setup : Accesses Menus that allow you to change
Picture, Sound and other TV Settings.
HDMI2 HDMI3 Video
Apps Setup
Miracast
Lock or unlock your device from the Home menu
This section describes how to lock or unlock specified device.
1
Press SOURCE on the Remote Control.
2
Use J K to Select a device to lock or unlock.
3
Press OPTIONS on the Remote Control.
4
Use H I to Select Lock or Unlock, then press OK.
If device lock is unlocked, Lock will be displayed. If device lock is
●
locked, Unlock will be displayed at the top right of the device
icons.
5
Enter your PIN. Change PIN L p. 37
Once you have set PIN, PIN input menu does not appear after the
●
unit is Turned on.
Changing device type
You can change device icons displayed in the source list.
1
Press SOURCE on the Remote Control.
2
Use J K to Select the desired device.
3
Press red button on the Remote Control.
4
Use H I to Select the desired type, then press OK.
To reset the type
Press OPTIONS on the Remote Control at step 3, then select Original
●
icon.
Scan connections
You can rescan TV connections and update the source list.
Before you begin:
You must set On in fun-Link control. L p. 34
1
Press SOURCE on the Remote Control.
2
Use J K to move the cursor to any device.
3
Press OPTIONS on the Remote Control.
4
Use H I to Select Scan connections, then press OK.
20 .
English
Continued on next page.