Oki Okipage 8z Quick Setup

Quick
Setup
Before you can use your printer:
q
Steps 1 to 5 - Setup your printer.
q
Step 6 - Install the correct Interface cable for your system—USB or Parallel.
q
Step 7 - Determine your computer's Operating System—Windows
Macintosh ® (OS 8.1 or higher), then install the correct printer software for your computer's
Operating System and Interface.
q
See the on-line User's Guide for more information about your printer.
1
Check Contents
Ê
Printer
Ë
Paper Feed Tray
Ì
Toner
Í
Power Cord
Î
CD
Ï
Light-Shield Bag (to protect image
drum from light when it is removed
from printer)
Quick Setup Instructions
! Interface cable is not included. For
information on cable requirements, see
"Supplies" in the on-line User's Guide.
©
2000 Oki Data Americas, Inc.
2
Align tabs on bottom of paper tray
into slots on back of printer.
® 95, 98, 2000, NT ® 4.0 or
3

Install the Paper Feed Tray

Swing tray up and align tabs
and slots at top.

Remove the Protective Sheet

Tilt up the image drum and lift it out. Do not
Lift the cover.
touch image drum's green surface.
Replace the image drum, tilting it down
to slide under the guides .
Press to lock tray in place.
Pull out sheet , and remove tape
If transparent film is attached, remove
film with sheet.
Press down firmly until drum snaps into place.
58341901
.