Form Tear Off
The Form Tear Off feature allows you to advance continuous forms to the
stacker for tear off.
The printer default for Forms Tear Off is Off. To use this feature, you must
enter the Function Settings Menu and turn it on.
Turn On Forms Tear Off
1. Press SEL.
The printer goes off-line.
2. Simultaneously press SHIFT and MODE to enter the Function Settings
Menu.
PRINTER CONTROL
3. Press and hold SHIFT, then press FF repeatedly until
displays.
4. Press FF repeatedly until
5. Press MODE repeatedly until the interval you want to select (2 seconds,
1 second, or 500 milliseconds) displays.
6. Press LOAD: this saves your setting and exits the menu mode.
Move Continuous Forms Up for Tear Off
Press the SHIFT/TEAR switch to move continuous forms to the tear off
position.
8810_3_crop.jpg
displays.
FORM TEAR-OFF
Microline 8810 User's Guide
75
FRONT FEED
displays.