Table of Contents
Advertisement
Fitting the turntable
1
Insert the centre spindle in the
centre hole of the turntable.
Attention
z Be careful when handling the turntable, as
it is heavy.
z Wipe off fingerprints or dirt with a soft cloth.
2
Slowly lower the turntable while
aligning the rotor shaft fix holes
(three locations) with the rotor
shafts.
z Turn the turntable in both directions to
align the holes with the rotor shafts.
Attention
z If the rotor shafts are misaligned, a gap
remains between the turntable and main
unit and you cannot mount the turntable
correctly. Do not force the turntable
downward.
3
Attach the washers, belleville
springs, and screws for turntable to
the rotor shaft fix holes, and tighten
the mounting screws securely.
Attention
z When tightening screws,
do not allow screw heads
to protrude from the top
surface of the turntable.
z Tighten the three screws
evenly.
To remove the turntable
„
Loosen the mounting screws for turntable
and remove them.
- Keep the screws, belleville springs, and
washers carefully.
k
Hold the turntable with both hands and
slowly pull it straight up.
Fitting the turntable mat
4
Lay the turntable mat on the
turntable.
Attaching the head shell
5
Fit the head shell with the
cartridge into the tone arm.
Keep the head shell horizontal
and tighten the locking nut.
z Be careful not to touch the stylus tip.
Locking nut
Head shell
0
Attaching the balance weight
6
Attach the balance weight to the
rear of the tone arm.
Balance weight
Auxiliary weight
z Attach the included auxiliary weight to the
rear of the tone arm according to the weight
of your cartridge.
For adjustable cartridge weight ranges, see
"Applicable cartridge weight range". (
Note
z The inside of the balance weight is greased.
25)
13
(13)
English
Advertisement
Table of Contents
