Error And Maintenance Messages - Brother DCP-L8400CDN Basic User's Manual

Error and maintenance messages

As with any sophisticated office product, errors may occur and supplies may be replaced. If this
happens, your machine identifies the error or required routine maintenance and displays the
appropriate message. The most common error and maintenance messages are shown in the
table.
You can clear most errors and perform routine maintenance yourself. If you need more help, the
Brother Solutions Center offers the latest FAQs and troubleshooting tips:
Visit http://solutions.brother.com/.
NOTE
The Touchscreen names are as follows.
• Multi-purpose tray: MP Tray
• Standard paper tray: Tray1
• Optional lower tray: Tray2
Error Message
2-sided Disabled
2-sided Disabled
Reload paper,
then press
[Retry].
Access Denied
Access Error
Belt End Soon
96
Cause
The back cover of the machine
is not closed completely.
Although the size of paper in
the paper tray matches the
paper size that was selected
from the control panel or printer
driver, the machine has
stopped printing when it
encountered an additional,
different size of paper in the
tray.
The paper tray was pulled out
before the machine completed
printing on both sides of the
paper.
The function you want to use is
restricted by Secure Function
Lock.
The device was removed from
the USB direct interface while
the data was processing.
The belt unit is near the end of
its life.
Action
Close the back cover of the machine until it
locks into the closed position.
Make sure the paper tray contains only the size
of paper you select in either the control panel or
printer driver, then press Colour Start or
Mono Start.
Reinstall the paper tray and press Colour
Start or Mono Start.
Contact your administrator to check your
Secure Function Lock Settings.
Press . Reinsert the device and try to print
with Direct Print.
Buy a new belt unit before you get a Replace
Belt message.
B