Switching Components On And Off Using The 12 Volt Trigger; Plugging In The Receiver - Pioneer VSX-90 Operating Instructions Manual

04

Switching components on and off using the 12 volt trigger

You can connect components in your system (such as a screen or projector) to this receiver so that they switch
on or off using 12 volt triggers when you select an input function. However, you must specify which input func-
tions switch on the trigger using the The Input Setup menu
ponents that have a standby mode.
12V TRIGGER
INPUT
12V
TRIGGER
(OUTPUT
12V
12V
TRIGGER
150 mA MAX)
% Connect the 12 V TRIGGER jack of this receiver to the 12 V trigger of another component.
Use a cable with a mono mini-plug on each end for the connection.
After you've specified the input functions that will switch on the trigger, you'll be able to switch the component on
or off just by pressing the input function(s) you've set on
on page 62 . Note that this will only work with com-
(OUTPUT
12V
150 mA MAX)
page 62 .
Connecting your equipment (In case of VSX-45)

Plugging in the receiver

Only plug in after you have connected all your components to this receiver, including the speakers.
CAUTION
! Handle the power cord by the plug part. Do not pull out the plug by tugging the cord, and never touch the
power cord when your hands are wet, as this could cause a short circuit or electric shock. Do not place the
unit, a piece of furniture, or other object on the power cord or pinch the cord in any other way. Never make a
knot in the cord or tie it with other cables. The power cords should be routed so that they are not likely to be
stepped on. A damaged power cord can cause a fire or give you an electric shock. Check the power cord once
in a while. If you find it damaged, ask your nearest Pioneer authorized independent service company for a
replacement.
! The receiver should be disconnected by removing the mains plug from the wall socket when not in regular use,
e.g., when on vacation.
%
Plug the AC power cord into a convenient AC power outlet.
51