Operation
1. Press TRANSMIT CH/MEMORY BULK DUMP
twice.
•
If the PortaSound is already in TRANSMIT CHANNEL
select mode (indicated by an
on the TEMPO/ PA-
RAMETER & VALUE display), press this button only
once.
The TEMPO/PARAMETER & VALUE display will start
to blink, showing that the PortaSound is ready for memory
bulk dump.
2. Press the VALUE + button.
This starts the bulk dump. (The TEMPO/PARAMETER
& VALUE display goes out during transmission.)
Completion of the bulk data dump is indicated by the
display lighting up again. The PortaSound then enters
TRANSMIT CH. select mode.
•
To exit Memory Bulk Dump mode without carrying out
the data dump, press TRANSMIT CH/MEMORY BULK
DUMP
again instead of the VALUE + button.
Reception
The PSS-680 will accept exclusive messages in ANY condition
— no particular setting is necessary. During reception, the
Portasound is totally inoperative, but one indicator dot will
blink to indicate MIDI communication. After a bulk dump,
the RAM contents of the receiving equipment will correspond
to that of the transmitting unit.
If reception of the bulk dump was not successful, the error
message
will appear on the display. In this case, repeat the bulk dump.
Note:
Only that part of the data where the error occurred is reset.
All other system exclusive data is received correctly. In
other words, if an error for instance occurred during
transmission of the digital synthesizer bank 1, only this
data will be reset while all other system exclusive data is
received as intended.
Received Data
With the exception of channel 16, all note ON/OFF data is
used to play the selected voice. Only MIDI note numbers
corresponding to the keyboard’s five octave range are ac-
cepted. Velocity data is NOT accepted in this mode, but can
be received in Sound Source mode 99.