Threading The Lower Thread; Einfädeln Des Unterfadens; Enfilage Du Fil Inférieur; Enhebrado Del Hilo Inferior - Brother SL-7360 Instruction Manual

Single needle straight lock stitcher
Table of Contents

Advertisement

c Threading the lower thread
c Einfädeln des Unterfadens
c Enfilage du fil inférieur
c Enhebrado del hilo inferior
CAUTION/ACHTUNG/ATTENTION/ATENCION
¡
Turn off the power switch before installing the bobbin case, otherwise the machine may operate if the treadle
is pressed by mistake, which could result in injury.
¡
Schalten Sie den Netzschalter vor dem Einsetzen der Spulenkapsel aus, weil Verletzungen entstehen können,
wenn sich die Maschine durch unbeabsichtigtes Drücken des Pedals in Gang setzt.
¡
Mettre l'interrupteur d'alimentation sur la position d'arrêt avant d'installer la boîte à canette, sinon la ma-
chine risquera de se mettre en marche si on enfonce accidentellement la pédale, et donc de causer des
blessures.
¡
Desconectar el interruptor principal antes de instalar la caja de la bobina, de lo contrario la máquina podría
comenzar a funcionar si por descuido se pisara el pedal, lo que podría resultar en heridas.
r
1. Tout en tenant la canette de manière que le fil se bobine vers la droite, insérer la canette dans la boîte à canette.
2. Passer le fil à travers la fente
3. Vérifier que la canette tourne bien dans le sens des aiguilles d'une montre lorsqu'on tire le fil.
r
4. Tenir le verrou
de la boîte à canette et insérer la boîte à canette dans le crochet rotatif.
1. Sosteniendo la bobina de manera que el hilo se enrrolle hacia la derecha, insertar la bobina dentro de la caja de la
bobina.
2. Pasar el hilo por la ranura
3. Verificar que la bobina gira hacia la derecha cuando se tira del hilo.
r
4. Sostener el seguro
w
e
q
et sous le ressort de tension
q
y debajo del resorte de tensión
en la caja de la bobina e insertar la caja de la bobina dentro de la lanzadera.
1. While holding the bobbin so that the thread winds to the
right, insert the bobbin into the bobbin case.
2. Pass the thread through the slot
sion spring
q
e
.
3. Check that the bobbin turns clockwise when the thread
is pulled.
4. Hold the latch
bin case into the rotary hook.
1. Halten Sie die Spule, so daß sich der Faden auf die
rechten Seite aufgewickelt wird und setzen Sie die Spule
in die Spulenkapsel.
2. Führen Sie den Faden durch den Schlitz
Spannungsfeder
Fadenführung
3. Kontrollieren Sie, ob sich die Spule beim Herausziehen
des Fadens nach rechts dreht.
4. Halten Sie die Spulenkapsel an der Lasche
Sie sie in den Drehgreifer ein.
w
, puis le tirer hors du guide-fils
w
, y luego tirar de él hacia afuera de la guía de hilo
– 18 –
q
w
, and then pull it out from the thread guide
r
on the bobbin case and insert the bob-
w
und ziehen Sie den Faden an der
e
heraus.
e
and under the ten-
q
und unter die
r
und setzen
.
e
.
SL-7360

Advertisement

Table of Contents
loading

Table of Contents