Use Your Tv; Switching On Your Tv And Putting It In Standby Mode; Adjusting Volume; Switching Channels - Philips 55PFL7900 User Manual

4 Use your TV

Switching on your TV and putting it in
Standby mode
TV
Remote Control
To Turn the TV On from Standby or Off to Standby
•
Press on the Side panel or the Remote Control.
Note(s)
•
Energy Consumption contributes to air and water pollution. When the AC Power Cord is plugged
in, your TV consumes energy with a very low Standby Power Consumption.

Adjusting Volume

TV
Remote Control
To decrease or increase Volume
•
Press VOL / on the Side panel or press VOL + / – on the Remote
Control.
(–) : Volume Down
VOL
VOL (+) : Volume Up
To mute or unmute sound
•
Press on the Remote Control to mute the sound.
•
Press again or VOL + / – to recover the original sound.

Switching Channels

TV
Remote Control
To Select Channels by using CH
•
Press CH (Up) / (Down) on the side panel or press CH + / – on the
Remote Control.
To Select Channels by using the NUMBER buttons
Digital TV Operation
•
For Digital channels, press a number followed by a dot "•" and the
corresponding sub channel number.
–When selecting Digital channel 1 1. 1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
–When selecting Cable or Analog channel 1 1
Press PREV.CH to return to the previously viewed channel.
Note(s)
•
To Select the non-memorized channels, use the NUMBER buttons.
•
Channel not available or No signal will appear on the TV screen after the subchannel broadcast
is over.
•
Audio only message will appear on the TV screen, when you receive only sound signal.
21
/ or CH + / –
Continued on next page.
.
English