Assembly Of Lcd Display Panel - Liebert UHA1R-0100 User Manual

Control port
Unauthorized personnel are prohibited from opening the cover of the 10A charger.

8.8 Assembly Of LCD Display Panel

UF-LCD-ITA-0100 is an option for LCD display panel of the ITA 10kVA UPS, and its commissioning has been
completed before delivery. You need to install the assembly of the LCD display panel corresponding to the UPS.
Refer to 4.2 LCD Display Panel for the menu structure, function description and interface of the LCD display panel
assembly. The appearance of the LCD display panel assembly is shown in Figure 8-17.
The LCD display panel has been installed before delivery. If you need a LCD display panel (optional), remove the
LED display panel first, and then install the LCD display panel.
Before replacing the display panel, you must ensure that the UPS has been powered off, the bypass MCB, input MCB and
external output MCB are open.
The replacement procedures are as follows:
1. Make sure that the UPS is powered off, bypass MCB and I/O MCBs are open, and the battery cables has been
disconnected.
2. Press the two ends of the UPS plastic panel by hand, gently pull the plastic panel outwards to remove it, as shown
in Figure 8-18 (a).
AC input
Power linker
(with sliding panel)
Figure 8-16 Rear panel of 10A charger
Figure 8-17 Appearance of LCD display panel assembly
Liebert ITA 10kVA UPS User Manual
®
Input switch
Ventilation hole
Button
Slide
AC input amplified
警告 危 险
Note
警告 危 险
Note
Chapter 8 Options
Battery port
PP30 terminal
59