OK International DX-250 User Manual

Precision dispensers
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Quick Links

OK International
DX-250 / 255
Precision Dispensers
User Guide
English, Simplified Chinese, Traditional Chinese and Korean Version
DX-250 / 255
DX-250 / 255
精密点胶机
精密點膠機
用户指南
使用者指南
Copyright © OK International
DX-250 / 255
정밀 디스펜서
사용설명서
CONTENTS
1
Safety....................................................................................................2 - 3
2
Symbol Definitions...............................................................................3
3
Specifications .......................................................................................3
4
Features ................................................................................................4
5
Connecting the Unit..............................................................................5
6
Setup Instructions .................................................................................5 - 6
7
Troubleshooting ...................................................................................6
8
Maintenance .........................................................................................7
9
Spare Parts and Accessories .................................................................7
10 Warranty ...............................................................................................7
11
I/O Configuration and End of Cycle Switch .......................................7
SAFETY
1
1.1 Intended Use:
WARNING: Use of this equipment in ways other than those described in this User
Guide may result in injury to persons or damage to property. Use this equipment
only as described in this User Guide.
OK International cannot be responsible for injuries or damages resulting from
unintended applications of its equipment. Unintended uses may result form taking
the following actions:
• Making changes to equipment that has not been recommended in the User
Guide
• Using incompatible or damaged replacement parts
• Using unapproved accessories or auxiliary equipment
1.2 Safety Precautions:
• Do not operate this unit in excess of maximum ratings/settings
• Always wear appropriate personal protective clothing or apparel
• Use only the following power adaptor models: PSA15R-240P(ZJ) or
PW118RA2403B01, PW118RA2403H01, PW118RA2403M01,
PW118RA2403G01
• Care must be taken to prevent the ingress of corrosive or flammable fluid back
into the unit. If corrosive or flammable fluids are used, an inline filter (881-
000-000) must be installed on the dispenser to help prevent the fluids from
being sucked back into the unit
Page Number
2

Advertisement

Chapters

Table of Contents
loading

Summary of Contents for OK International DX-250

  • Page 1: Table Of Contents

    Guide may result in injury to persons or damage to property. Use this equipment only as described in this User Guide. OK International cannot be responsible for injuries or damages resulting from unintended applications of its equipment. Unintended uses may result form taking the following actions: •...
  • Page 2: Symbol Definitions

    -10˚C to 60˚C (14˚F to 140˚F) 80% for temperature up to 31˚C (87.8˚F) Decreasing Max. Relative Humidity linearly to 50% relative humility at 40˚C (104˚F) DX-250 = 0-100 psi (0-6.9 bar) Air Output DX-255 = 0-15 psi (0-1.03 bar) Vacuum 406mm (16”) of Hg...
  • Page 3: Connecting The Unit

    CONNECTING THE UNIT CAUTION: A 5-micron filter (TSD800-6), not included, must be installed with the unit to ensure proper air filtration. Figure 2.0 Items Description To Air Source Air Filter (Not Included) Power Adapter Foot Switch SETUP INSTRUCTIONS Refer to Figure 1.0 Manual Dispense Cycle Setting: 1.
  • Page 4: Maintenance

    3xx/2xx User Guide webpage at http://www.okinternational.com 10 LIMITED WARRANTY OK International warrants this product to the original purchaser for a period of one (1) year from date of purchase to be free from material and workmanship defects but not normal wear-and-tear, abuse and faulty installation. Defective product or subassembly and components under warranty will be repaired or replaced (at OK International's option) free of charge.
  • Page 5 操作温度 0°C 到 50°C(32°F 到 122°F) 储藏温度 -10°C 到 60°C(-10.00°C 到 60.00°C) 温度是 31°C (87.8°F) 时为 80%,达到 40°C (104°F) 时 最大相对湿度 会线性降至 50% DX-250 = 0-100 psi(0-6.9 巴) 排气量 DX-25 = 0-15 psi(0-1.03 巴) 真空 406mm (16")(水银汞柱) 计时器 0.020-60.000 秒...
  • Page 6 功能 图 1.0 条目 说明 电源按钮 模式按钮 计数器按钮 显示 气压计 气压调节器 脉冲气体出口 真空控制器 时间调节旋钮 气管支架 脚踏开关插座 电源插座 I/O 连接 排放口 进气口 绳扣 连接设备 注意:此设备必须安装 微米的过滤网 条目 说明 目标气源 气体过滤器 (随机不带) 电源适配器 脚踏开关 设置说明 请参见图 1.0 6.1 手动/排胶点胶循环设置: 按“电源”按钮 (1) 打开设备。 按“模式”按钮...
  • Page 7 有关 DX-3xx/2xx 备件和附件的信息,请访问 • 打开电源 站中的 DX-3xx/2xx“用户指南”网页。 检查脚踏开关的连接 • • 维修或更换脚踏开关 10 有限保修 • 拔去电源线,断开气 源。除去封盖,检查 OK International 保证原始购置的产品从购买日起算一年 之内不发生材料和工 受损的电线或连接不 艺故障,但不包括正常的磨损、滥用以及错误安装。属于保修范围内的次品或 牢固处 有故障的部件和组件会得到免费维修或更换(取决于 OK International 的选 • 更换螺线管 择)。顾客如果出现保修范围内的产品故障,须联系最近的 OK International • 更换 PC 板 办事处或经销商,以确保在将产品运送到指定 OK International 授权服务中心 •...
  • Page 8 維護 ... 8 備用零件與附件 ... 8 10 保固 ... 8 11 I/O 組態與結束循環開關 ... 8 安全性 1.1 用途: 警告: 以本「使用者指南」中所描述的以外方式使用本設備可能會導致人身 的傷害或財產的損失。 請您務必依照本「使用者指南」中所描述的方法來使 用此設備。 OK International 對於將本設備應用於非計畫目的所造成的傷害或損壞,不負 擔任何責任。 執行下列動作將可能導致非計畫的使用: • 更換為本使用者指南中不建議的設備 • 使用不相容或已損壞的更換零件 • 使用未核准的附件或輔助設備 1.2 安全預防措施: • 操作本裝置時請勿超過最大功率/設定 • 始終穿著適當的個人防護衣物或服裝 頁碼...
  • Page 9: 規格說明

    0°C 到 50°C (32°F 到 122°F) 儲存溫度 -10°C 到 60°C (14°F 到 140°F) 溫度達到 31°C (87.8°F) 時為 80%,達到 40°C 最大相對溼度 (104°F) 時直線減少為 50% DX-250 = 0-100 psi (0-6.9 bar) 空氣輸出 DX-255 = 0-15 psi (0-1.03 bar) 真空度 406mm (16”) - Hg 計時器...
  • Page 10: 連接裝置

    連接裝置 注意: 本裝置必須安裝有 5-微米過濾器 隨機不帶,以確保適當的空氣過濾。 (TSD800-6), 圖 2.0 項目 說明 目標空氣來源 空氣過濾器 (隨機不帶) 電源變壓器 腳踏開關 安裝說明 請參考圖 1.0 6.1 手動/排膠點膠循環設定: 1. 按下電源按鈕 (1) 開啟裝置。 2. 按下模式按鈕 (2) 直到顯示幕上出現 “PURGE” (手動模式) 為止。 3. 旋轉氣壓調節器把手 (6) 調昇氣壓直到想要的壓力出現在氣壓表 (5) 中。 4. 在將針桶裝滿或使用預裝膠黏劑時,連接注射器與接收器頭組件。 確 定注射器已鎖至定位。...
  • Page 11: 維護

    본 장비를 사용설명서에 명시된 것과 다른 방법으로 사용할 경우 인명 또는 재산 피해를 초래할 수도 있습니다 사용하여 주십시오 OK International 은 본 장비를 본래 용도 이외의 용도에 사용한 데 따른 일체의 인적, 물적 피해에 대하여 책임을 지지 않습니다. 다음과 같은 행위를 할 경우 오용으로 이어질 수 있습니다.
  • Page 12 보관 온도 -10˚C - 60˚C (14˚F - 140˚F) 최대 31˚C 까지 80% (87.8˚F) 40˚C(104˚F)에서 상대 최대 상대 습도 습도 50%까지 선형으로 감소 DX-250 = 0-100 psi (0-6.9 bar) 배출 공기 DX-255 = 0-15 psi (0-1.03 bar) 진공 406mm (16 인치) 헥토그램...
  • Page 13 기능 그림 1.0 항목 설명 전원 버튼 모드 버튼 카운터 재설정 버튼 디스플레이 공기 압력 게이지 공기 압력 제어기 정화된 공기 출구 진공 제어 시간 제어 손잡이 페달식 스위치 콘센트 전원 콘센트 I/O 연결 액세서리 공기 배출 배출 포트 공기 주입구 코드...
  • Page 14 진공 “흡입부 뒷부분”에, 필요하다면, 진공 게이지(9)에 압력이 표시될 때까지 진공 제어기(8) 카운터를 시계 방향(오른쪽)으로 돌려주십시오. 페달 스위치를 누른 채로 있으면 디스펜스 주기가 활성화 됩니다 (이제 수동/정화 모드가 활성화 됩니다). 자동 디스펜스 주기 설정 1. 모드 버튼(2)을 눌러 “자동방식” 또는 “중지” 모드를 선택하십시오. 2.
  • Page 15 사용설명서 웹 페이지를 확인하시기 바랍니다. http://www.okinternational.com 10 제한 보증 OK International 은 최초 구매자를 대상으로 소재 및 제조 상의 결함에 한해 (1)년 동안 본 제품을 보증하여 드리되, 일반적인 마모나 긁힘, 오용 및 잘못된 설치 등은 제외합니다. 보증에 의거하여 결함이 있는 제품이나 부속품 및...

This manual is also suitable for:

Dx-255

Table of Contents