Brother DCP-J562DW Online User's Manual page 380

c. Select [WPS w/PIN Code]. Press OK.
3. When [Enable WLAN?] appears, press OK.
This will start the wireless setup wizard. To cancel, press Stop/Exit.
4. The LCD displays an eight-digit PIN and the machine starts searching for a wireless LAN access point/router.
5. Using a computer that is on the network, type "http://access point's IP address" in your browser (where
"access point's IP address" is the IP address of the device that is being used as the Registrar).
6. Go to the WPS settings page and type the PIN, and then follow the on-screen instructions.
• The Registrar is usually the wireless LAN access point/router.
• The settings page will differ depending on the brand of wireless LAN access point/router. For more
information, see the instructions supplied with your wireless LAN access point/router.
If you are using a Windows Vista
following steps:
7. Do one of the following:
®
• (Windows Vista
Click (Start) > Network > Add a wireless device.
®
• (Windows 7)
Click (Start) > Devices and Printers > Add a device.
®
• (Windows 8)
Move your mouse to the lower right corner of your desktop. When the menu bar appears, click Settings >
Control Panel > Hardware and Sound > Devices and Printers > Add a device.
• To use a Windows Vista
your network in advance. For more information, see the instructions supplied with your wireless LAN
access point/router.
• If you use Windows
configuration by following the on-screen instructions. To install the full driver and software package, use
the Brother Installation CD-ROM.
8. Select your machine and click Next.
9. Type the PIN displayed on the machine's LCD, and then click Next.
10. Select your network, and then click Next.
11. Click Close.
DCP-J562DW/MFC-J680DW/MFC-J880DW
1. Press [Settings] > [All Settings] > [Network] > [WLAN] > [WPS w/ PIN Code].
2. When [Switch Network interface to wireless?] or [Enable WLAN?] appears, press [Yes].
This will start the wireless setup wizard. To cancel, press [No].
3. The LCD displays an eight-digit PIN and the machine starts searching for a wireless LAN access point/router.
4. Using a computer that is on the network, type "http://access point's IP address" in your browser (where
"access point's IP address" is the IP address of the device that is being used as the Registrar).
5. Go to the WPS settings page and type the PIN, and then follow the on-screen instructions.
• The Registrar is usually the wireless LAN access point/router.
• The settings page will differ depending on the brand of wireless LAN access point/router. For more
information, see the instructions supplied with your wireless LAN access point/router.
®
, Windows
)
® ®
, Windows 7, or Windows
® ®
7 or Windows 8 as a Registrar, you can install the printer driver after the wireless
® ®
7, or Windows 8 computer as a Registrar, complete the
®
8 computer as a Registrar, you must register it to
374