Assembly - Makita LS0815F Instruction Manual

simply pull the switch trigger without pressing the
lock-off button. A switch in need of repair may
result in unintentional operation and serious
personal injury. Return tool to a Makita service
center for proper repairs BEFORE further usage.
NEVER defeat the lock-off button by taping down
•
or some other means. A switch with a defeated
lock-off button
operation and serious personal injury.
Electronic function
Soft start feature
This function allows the smooth start-up of the tool
•
by limiting the start-up torque.
Laser beam action
For model LS0815FL only
NOTE:
Before the first use, install the dry cells provided
•
separately from the tool in the cell box. Refer to
the section titled "Replacing the dry cells for laser
unit" for the installment.
CAUTION:
When not in use, be sure to turn off the laser
•
Fig.18
CAUTION:
Never look into the laser beam. Direct laser beam
•
may injure your eyes.
LASER RADIATION, DO NOT STARE INTO THE
•
BEAM OR VIEW DIRECTLY WITH OPTICAL
INSTRUMENTS, CLASS 2M LASER PRODUCT.
Before shifting the laser line or performing
•
maintenance adjustment, be sure to unplug the
tool.
To turn on the laser beam, press the upper position
(ON) of the switch. To turn off the laser beam, press the
lower position (OFF) of the switch.
Laser line can be shifted to either the left or right side of
the saw blade by loosening the screw holding the laser
unit box and shifting it in the desired direction. After
shifting, be sure to tighten the screw.
1
1. Screw holding the laser unit box
014275
may result in unintentional
Laser line is factory adjusted so that it is positioned
within 1 mm from the side surface of the blade (cutting
position).
NOTE:
When laser line appears dim and hard to see
•
because of direct sunlight, relocate the work area
to a place where there is less direct sunlight.
Cleaning of the lens for the laser light
If the lens for the laser light becomes dirty, or sawdust
adheres to it in such a way that the laser line is no
longer easily visible, unplug the saw and remove and
clean the lens for the laser light carefully with a damp,
soft cloth. Do not use solvents or any petroleum-based
cleaners on the lens.
NOTE:
When laser line is dim and almost or entirely
•
invisible because of the direct sunlight in the
indoor or outdoor window-by work, relocate the
work area to a place not exposed to the direct
sunlight.
Light action
Fig.19
Fig.20
To turn on the light, press the upper position (ON) of the
switch. To turn off the light, press the lower position
(OFF) of the switch.
CAUTION:
Do not look in the light or see the source of light
•
directly.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it
•
may to lower the luminance.

ASSEMBLY

WARNING:
Always be sure that the tool is switched off
•
and unplugged before working on the tool.
Failure to switch off and unplug the tool may result
in serious personal injury.
Storage of socket wrench with hex wrench on
its other end
Fig.21
The socket wrench is stored as shown in the figure.
When the socket wrench is needed it can be pulled out
of the wrench holder. After using the socket wrench it
can be stored by returning it to the wrench holder.
13