Install Grill - KitchenAid KGCP467JSS Installation Instructions Manual

36" (91.4 cm) and 48" (121.9 cm) commercial style gas cooktop
Hide thumbs Also See for KGCP467JSS:
Table of Contents

Advertisement

Available languages

Available languages

3. Install the pressure regulator with the arrow pointing up
toward the bottom of the burner box and in a position where
you can reach the regulator cap.
IMPORTANT: All connections must be wrench-tightened. Do
not make connections to the gas regulator too tight. Making
the connections too tight may crack the regulator and cause
a gas leak. Do not allow the regulator to turn on the pipe
when tightening fittings.
Use only pipe-joint compound made for use with Natural and LP
®†
gas. Do not use TEFLON
tape.
You will need to determine the fittings required depending on
your installation.
Typical flexible connection
1. Apply pipe-joint compound made for use with LP gas to the
smaller thread ends of the flexible connector adapters (see C
and F in following illustration).
2. Attach one adapter to the gas pressure regulator and the
other adapter to the gas shutoff valve. Tighten both adapters.
3. Use a ¹⁵⁄₁₆" combination wrench and channel lock pliers to
attach the flexible connector to the adapters. Check that
connector is not kinked.
A
B
C
H
D
E
G
F
A. Gas pressure regulator
E. Use pipe-joint compound
B. Use pipe-joint compound
F. Adapter
C. Adapter - Must have ½"
G. ½" or ¾" gas pipe
male pipe thread
H. Manual gas shutoff valve
D. Flexible connector
Complete Connection
1. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A
B
A. Closed valve
B. Open valve
2. Test all connections by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show a
leak. Correct any leak found.
3. Remove surface burner caps and grates from parts package.
Align notches in burner caps with pins in burner base. Burner
caps should be level when properly positioned. If burner caps
are not properly positioned, surface burners will not light.
Place burner grates over burners and caps.
B
A
C
A. Igniter electrode
B. Burner cap
C. Burner base
4. If your cooktop only has surface burners, see “Check
Operation of Surface Burners, Grill and Griddle” section in the
“Complete Installation” section.
If your model was shipped with a grill or griddle, see “Install
Grill” or “Install Griddle” section.

Install Grill

(on some models)
1. Remove twist tie and discard. Lift burner assembly out of
basin and set aside.
A
A. Burner assembly
2. Place drip tray on bottom of grill basin and slide the tray
toward the back so that it is located side to side and against
the locating feet of the rear spill guard.
A
B
C
A. Rear spill guard
B. Locating feet
C. Drip tray
Page 10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents