Download  Print this page

Camshaft Chain Tensioner Installation - Kawasaki KLX110 Service Manual

Hide thumbs

Advertisement

Table of Contents
Camshaft Chain Tensioner

Camshaft Chain Tensioner Installation

Remove the tensioner cap bolt and O-ring.
While compressing the push rod [A], turn it clockwise [B] with a
suitable screwdriver until the rod protrusion comes to about 10 mm
from the tensioner body.
Do not turn the rod counterclockwise at installation. This could
detach the rod and the tensioner cannot be reinstalled.
While holding the rod in position with a suitable push rod holder plate
[A] install the tensioner on the cylinder block.
Tighten the mounting bolts [A].
Torque -
Chain Tensioner Mounting Bolts: 5.2 N
in
lb)
1
Take out the holder plate.
Install the O-ring and tighten the cap bolt.
Torque -
Tensioner Cap Bolt: 5.2 N
Install the left side cover.
CAUTION
m (0.53 kgf
1
m (0.53 kgf
m, 46 in
1
1
m, 46
1
lb)
1
ENGINE TOP END 4-9

Advertisement

Table of Contents

   Also See for Kawasaki KLX110

Comments to this Manuals

Symbols: 0
Latest comments: