Periodic Maintenance Procedures
Before lubricating each part, clean off any rusty spots with rust
remover and wipe off any grease, oil, dirt, or grime.
Lubricate the points listed below with indicated lubricant.
Whenever the vehicle has been operated under wet or rainy
conditions, or especially after using a high-pressure water spray,
perform the general lubrication.
Pivots: Lubricate with Motor Oil.
Brake Rod Joint
Points: Lubricate with Grease [A].
Throttle Cable Upper End
Choke Cable Lower End
Side Stand Pivot
Steering Stem Bearing
Cables: Lubricate with Rust Inhibitor.
Throttle Cable [A]
Front Brake Cable
PERIODIC MAINTENANCE 2-21