Download  Print this page

Advertisement

Table of Contents
Periodic Maintenance Procedures

Steering Adjustment

Remove the number plate.
Using the jack, raise the front wheel off the ground.
Special Tool -
jack: 57001–1238
Remove the handlebar.
Loosen the front fork lower clamp bolts [A] and steering stem head
nut [B].
Turn the steering stem locknut [A] with the steering stem nut wrench
[B] to obtain the proper adjustment.
If the steering is too tight, loosen the stem locknut a fraction of a turn;
if the steering is too loose, tighten the locknut a fraction of a turn.
Special Tool -
Steering Stem Nut Wrench: 57001–1100
Turn the locknut 1/8 turn at a time maximum.
Tighten the following:
Torque -
Steering Stem Head Nut: 44 N
Front Fork Lower Clamp Bolts: 29 N
Mount the handlebar clamps [B] so that the arrows [C] on the clamp
point at the front [A].
Align a gap [E] at the rear with the punch mark [D] on the handlebar.
NOTE
m (4.5 kgf
m, 32 ft
1
1
m (3.0 kgf
m, 22 ft
1
1
PERIODIC MAINTENANCE 2-19
lb)
1
lb)
1

Advertisement

Table of Contents

   Also See for Kawasaki KLX110

Comments to this Manuals

Symbols: 0
Latest comments: