Download  Print this page

Ignition System; Igniter Removal; Pickup Coil Resistance Measurement - Kawasaki KLX110 Service Manual

Hide thumbs

Advertisement

Table of Contents

Ignition System

The ignition system produces extremely high voltage. Do not
touch the spark plug, ignition coil, or spark plug lead while
the engine is running, or you could receive a severe electrical
shock.
Do not disconnect the electrical connections while the engine
is running. This is to prevent igniter damage.
The negative side is grounded. This is to prevent damage to
the diodes and Igniter.

Igniter Removal

Remove:
Seat
Connector [A]
Igniter [B]
Exciter Coil Resistance Measurement
Remove the left side cover.
Disconnect the magneto lead connector [A].
Set the hand tester to the x 10
from the exciter coil to check the resistance.
Special Tool -
Hand Tester: 57001–1394
If the reading is not the specified value, replace the stator.
Exciter Coil Resistance
Tester
Range
Tester Lead
x 10
Ground
Ground

Pickup Coil Resistance Measurement

Remove the left side cover.
Disconnect the magneto lead connector [A].
Set the hand tester to the x 100
from the pickup coil to check the resistance.
Special Tool -
Hand Tester: 57001–1394
If the reading is not the specified value, replace the stator.
Pickup Coil Resistance
Tester
Range
Tester Lead
x 100
Ground
CAUTION
range, and connect it to the leads
Connections
Another Lead
White Lead
Yellow Lead
range, and connect it to the lead
Connections
Another Lead
Blue/Yelow Lead
ELECTRICAL SYSTEM 14-11
Unit:
Reading
0.2
1.0
0.1
0.8
Unit:
Reading
50
200

Advertisement

Table of Contents

   Also See for Kawasaki KLX110

Comments to this Manuals

Symbols: 0
Latest comments: