Download  Print this page

Steering Stem Race Installation Notes; Steering Stem Bearing Lubrication; Steering Stem Bearing Inspection; Steering Stem Warp - Kawasaki KLX110 Service Manual

Hide thumbs



Steering Stem Race Installation Notes

Apply engine oil to the outer races, and then drive them into the head
pipe using the bearing driver set [A].
Special Tool -
Bearing Driver Set: 57001–1129
Drive the lower inner race [A] onto the steering stem using the stem
bearing driver [B].
Special Tool -
Steering Stem Bearing Driver: 57001–137

Steering Stem Bearing Lubrication

Refer to Steering Stem Bearing Lubrication in the Periodic Mainte-
nance Chapter.

Steering Stem Bearing Inspection

Using a high-flash-point solvent, wipe the bearings clean of grease
and dirt.
Check the races and balls.
If the balls or races are worn, or if either race is dented, replace both
races and all the balls for that bearing as a set.

Steering Stem Warp

Whenever the steering stem is removed, or if the steering cannot be
adjusted for smooth action, check the steering stem for straightness.
If the steering stem shaft [A] is bent, replace the steering stem.


Table of Contents

   Also See for Kawasaki KLX110

Comments to this Manuals

Symbols: 0
Latest comments: