Download  Print this page

Advertisement

9-12 WHEELS / TIRES
Hub Bearing

Bearing Lubrication

Remove the hub bearings on the front and rear wheel hubs.
Wash the bearings with a high-flash-point solvent, dry them (do not
spin them while they are dry), and oil them.
Spin each bearings by hand to check its condition.
If it is noisy, does not spin smoothly, or has any rough spots, it must
be replaced.
If the same bearing is to be used again, re-wash it with a high-flash-
point solvent, and dry it.
Pack each bearings with good quality bearing grease [A] before
installation. Turn each bearing around by hand a few times to make
sure the grease is distributed uniformly inside the bearing, and wipe
the old grease out of the bearing housings on the wheel hub before
bearing installation.
Install the bearings.

Advertisement

Table of Contents

   Also See for Kawasaki KLX110

Comments to this Manuals

Symbols: 0
Latest comments: