Download  Print this page

Hub Bearing; Hub Bearing Removal; Hub Bearing Installation; Bearing Inspection - Kawasaki KLX110 Service Manual

Hide thumbs

Advertisement

Table of Contents

Hub Bearing

Hub Bearing Removal

Remove the wheel.
To remove the grease seals, pry out the grease seal using a
screwdriver.
Using the bearing remover shaft and bearing remover head, remove
the hub bearings [A].
Special Tools - Bearing Remover Shaft,
Bearing Remover Head,

Hub Bearing Installation

Before installing the hub bearings, blow any dirt or foreign particles out
the hub with compressed air to prevent contamination of the bearings.
Replace the bearings with new ones.
Install the bearings [A] using the bearing driver set [B] so that the
marked or shield sides face out.
Press in the bearings until they bottom out.
Special Tool -
Bearing Driver Set: 57001–1129
For correct tire alignment, the right bearing must be installed first
rather than left bearing in both front and rear hubs.
Replace the grease seal [A] with new ones.
Apply high-temperature grease to the grease seal lips.
Press in the grease seal so that the seal surface is flush [B] with the
end of the hole using the bearing driver set [C].
Special Tool -
Bearing Driver Set: 57001–1129

Bearing Inspection

Since the hub bearings are made to extremely close tolerances, the
clearance cannot normally be measured.
Do not remove any bearings for inspection. If any bearings
are removed, they will need to be replaced with new ones.
Turn each bearing in the hub back and forth [A] while checking for
plays, roughness, or binding. If bearing play, roughness, or binding
is found, replace the bearing.
Examine the bearing seal [B] for damage or leakage.
If the seal is damaged or is leaking, replace the bearing.
9: 57001–1265 [B]
10 X
12: 57001–1266 [C]
NOTE
CAUTION
WHEELS / TIRES 9-11

Advertisement

Table of Contents

   Also See for Kawasaki KLX110

Comments to this Manuals

Symbols: 0
Latest comments: