Download  Print this page

Rear Wheel Installation - Kawasaki KLX110 Service Manual

Hide thumbs

Advertisement

9-6 WHEELS / TIRES
Wheels (Rims)
Remove:
Adjusting Nut [A]
Cotter Pin [B]
Rear Torque Link Nut [C]
Rear Torque Link Bolt [D]
Cotter Pin [E]
Rear Axle Nut [F]
Do not depress the brake pedal deeply with the brake rod
inserted into the brake cam lever joint, this may elongate the
spring beyond its allowable spring extension.
To remove the brake rod end from the brake cam lever, first turn the
brake panel clockwise [A] as far as it will go, then depress the brake
pedal lightly, the brake rod [B] will be separated from the brake cam
lever joint [C].
Pull out the rear axle and remove the rear wheel from the rear wheel
coupling and from the motorcycle.

Rear Wheel Installation

Apply high-temperature grease to the grease seal.
Install the collar [A] on the left and right of the rear hub.
Install the rear wheel.
Install the drive chain.
Adjust the drive chain slack (see Final Drive chapter).
Turn the brake panel clockwise until the brake cam lever joint goes
beyond the brake rod end then insert the brake rod end into the joint
hole.
Do not insert the brake rod into the cam lever joint by
depressing the brake pedal deeply, this will extend the brake
spring beyond its allowable spring extension.
Tighten the rear axle nut.
Torque -
Rear Axle Nut: 64 N
Install the torque link [A] so that its "R" mark [B] faces rearward.
Tighten the torque link nuts.
Torque -
Torque Link Nut: 25 N
CAUTION
CAUTION
m (6.5 kgf
m, 47 ft
lb)
1
1
1
m (2.5 kgf
m, 18 ft
lb)
1
1
1

Advertisement

Table of Contents

   Also See for Kawasaki KLX110

Comments to this Manuals

Symbols: 0
Latest comments: