Download  Print this page

Advertisement

8-6 CRANKSHAFT / TRANSMISSION
Crankcase Splitting
Using a press and the bearing driver set, install new bearings until
they bottoms out.
Press the output shaft bearing [B] in the left crankcase half [A].
Special Tool -
Bearing Driver Set: 57001–1129
Apply high-temperature grease to the lips of the oil seals.
Press in the oil seals [C] of the left crankcase half so that the seal
surface is flush with the end of the hole.
Tighten the shift drum and drive shaft bearing retainer screws to the
right crankcase.
Torque -
Shift Drum Bearing Retainer Screws [B]: 2.9 N
26 in
lb)
1
Drive Shaft Bearing Retainer Screw [A]: 5.2 N
46 in
lb)
1
Insert the crankshaft jig [A] between the crankshaft flywheels opposite
the connecting rod big end to protect flywheel alignment. This tool is
easily adjustable to fit in any gap between the flywheel.
Special Tool -
Crankshaft Jig: 57001–1174
Fit the crankshaft into the right crankcase half using a press [A].
Install:
Shift Drum [A]
Transmission Shaft Assemblies [B]
Shift Forks [C]
Check that the shift drum is in neutral position.
m (0.3 kgf
m,
1
1
m (0.53 kgf
m,
1
1

Advertisement

Table of Contents

   Also See for Kawasaki KLX110

Comments to this Manuals

Symbols: 0
Latest comments: