Download  Print this page

Advertisement

5-8 CLUTCH
Clutches
Install:
Needle Bearing [A]
Primary Clutch Housing [B]
Needle Bearing [C]
Primary Clutch Sleeve [D]
If the one-way clutch and race dropped from the primary clutch
housing, install it as follows.
Put the one-way clutch [A] in the clutch housing halfway with the
rotation mark [B] facing out.
Fit the race [C] into the one-way clutch and push them together in the
clutch housing.
Install the plate with the line mark [A] facing out, nothing the proper
position.
Install the clutch hub.
Tighten the primary clutch nut while holding the primary clutch steady
with the primary clutch holder.
Special Tools - Primary Clutch Holder: 57001–1507
Torque -
Primary Clutch Hub Nut: 72 N
Install the ball bearing holder [A] and ball bearing [B].
Install the release lever [C] to the shift shaft, with shift shaft line [D]
aligning to release lever line [E].
Apply grease to the release cam and release ball assembly.
Install the release cam [A] and release ball assembly [B].
Install the clutch cover.
Adjust the clutch.
m (7.3 kgf
m, 53 ft
lb)
1
1
1

Advertisement

Table of Contents

   Also See for Kawasaki KLX110

Comments to this Manuals

Symbols: 0
Latest comments: