Audio; Schedule; Pip (Picture-In-Picture); Osm - NEC Multeos M40 User Manual

OSM Controls
CLOCK PHASE
VGA, RGB/HV, DVD/HD
input only
H RESOLUTION
DVI, VGA, RGB/HV
input only
V RESOLUTION
DVI, VGA, RGB/HV
input only
ZOOM MODE
INPUT RESOLUTION
VGA and RGB/HV input only
ADJUST RESET
BALANCE

AUDIO

TREBLE
BASS
PIP AUDIO
AUDIO RESET

SCHEDULE

OFF TIMER
SCHEDULE SETTING
SCHEDULE LIST
DATE & TIME
- continued
Adjusts the visual "noise" on the image.
Adjusts the horizontal size of the image.
Adjusts the vertical size of the image.
Select the aspect ratio of the screen image.
Choose the zoom method
BASE ZOOM
16:9 Same aspect ratio as the LCD panel.
14:9 14:9
DYNAMIC Expands a 4:3 picture to fill the screen in a non-linear (non-proportionate) manner and
some of the image will be lost due to expansion. DYNAMIC is the same as FULL size
image when HDTV 1080i signal is input.
OFF
Selecting "OFF" will display the image in a 1 by 1 pixel format. (If the input resolution is
higher than a 1920 x 1080 resolution, the image will be scaled down to fit the screen.
CUSTOM
Displays an image as large as possible without changing the aspect ratio or cutting off
part of the image.
ZOOM Maintains the aspect ratio while zooming.
Amount of horizontal zoom. Can be adjusted for each BASE ZOOM setting.
H ZOOM
V ZOOM Amount of vertical zoom. Can be adjusted for each BASE ZOOM setting.
Horizontal position. Can be adjusted for each BASE ZOOM setting.
H POS
V POS Vertical position. Can be adjusted for each BASE ZOOM setting.
If there is a problem with signal detection, this function forces the monitor to display the
signal at the desired resolution.
If no problem is detected, the only available option will be "AUTO".
AUTO
1024x768
1280x768
1360x768
1366x768
1440x1050
1680x1050
Resets the following settings within the ADJUST menu back to factory setting:
AUTO ADJUST, H POSITION, V POSITION, CLOCK, CLOCK PHASE, H RESOLUTION, V
RESOLUTION, ZOOM MODE, INPUT RESOLUTION.
Selects source of PIP audio.
Resets "AUDIO" options back to factory settings.
Sets the monitor to power off after a length of time between 1 and 24 hours.
Creates a working schedule for the monitor to use. See page 34 for instructions.
List of schedules.
Sets the date, time, and daylight saving region. Date & time must be set in order for the
"SCHEDULE" function to operate.
English-28
1-29