Kenwood TK-3107 Service Manual page 13

ADJUSTMENT FREQUENCY LIST
Destination
CH TX f (MHz)
Center
Low
Hi
Remarks
• Connect the transceiver to the PC
• Send the channel data to the transceiver, then backup
the data.
• Program the adjustment frequencies which are in the
list, into the transciever.
Note : Remember to reload the channel data you backed up
after making the adjustments.
1. Jig (chassis) for adjustment (part number A10-
1392-03)
2. Use the jig as follows:
1. Insert the coaxial antenna connector into the jig.
2. Place the unit on the jig and fix it with 12 screws.
3. Solder the antenna terminal to the terminal of the unit.
Notes: Supply power from an external power supply.
( )
Relay terminal : +
jig (chassis) : –
ADJUSTMENT / 调整
M6
RX f (MHz)
360.05
350.05
369.95
Coaxial antenna connector
JIG
Relay terminal
UNIT
TK-3107
13