Environmental Protection - Bosch AQUATAK 10 Operating Instructions Manual

Hide thumbs Also See for AQUATAK 10:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 13
F016 L70 896.book Seite 6 Mittwoch, 9. Mai 2012 11:03 11
Pressure pulsating
Pressure too low, but
steady
Note: Several types of ac-
cessory will normally de-
liver a lower pressure
Motor starts up but no
working pressure
The pressure washer
starts irregularly by itself
Water leaks from ma-
chine

Environmental Protection

Chemicals dangerous to the environment must not
be allowed to enter the ground, ground water or
ponds, streams, etc.
For the use of cleaning agents, observe the instruc-
tions on the package and the prescribed concentra-
tion exactly.
For the cleaning of motor vehicles the local regula-
tions should be observed: Do not allow oil sprayed
off to enter into the ground water. Recycle raw ma-
terials instead of waste disposal.
Disposal
Power tools, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical and
electronic equipment and its incorpo-
18 • F 016 L70 896 • 12.05
Air in the inlet water supply hose/pump
Inadequate water supply
Water strainer blocked
Water supply hoses squeezed
High pressure hose too long
Nozzle worn
Start/stop valve worn
No water supply
Water strainer clogged up
Nozzle clogged up
Pump/power gun leaky
Leaking pump
English - 6
Allow pressure washer to run with
open spray handle and nozzle at low
pressure until regular working pres-
sure is obtained
Check that the water supply corre-
sponds to specifications. The mini-
mum specification for the water supply
hose is 1/2" or 13 mm diameter
Clean water strainer
Straighten out kinked water supply
hoses
Dismount high pressure extension
hose. Retry (extension hose max. 7 m)
Change the nozzle
Activate trigger five time in quick suc-
cession
Connect water supply
Clean the water strainer
Clean nozzle
Contact your Bosch Service Centre
6 drops per minute are permissible. In
case of more serious leakage, you
should contact your Bosch Service
Centre
ration into national law, power tools that are no
longer suitable for use must be separately collected
and sent for recovery in an environmentally-friendly
manner.
Service
Exploded views and information on spare parts
can be found under:
www.bosch-pt.com
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham-Uxbridge
Middlesex UB 9 5HJ
Service
................................
Fax Service
...............................
Advice line
.........................
Fax Advice
.................................
+44 (0) 18 95 / 83 87 82
+44 (0) 18 95 / 83 87 89
+44 (0) 18 95 / 83 87 91
+44 (0) 18 95 / 83 87 93

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aquatak 100 plusAquatak ecoAquatak 100

Table of Contents