Starting And Stopping - Bosch AQUATAK 10 Operating Instructions Manual

F016 L70 896.book Seite 4 Mittwoch, 9. Mai 2012 11:03 11
Vario-jet-fan nozzle (lilac colour coded – only
AQUATAK ECO/100/100 PLUS)
Twist the nozzle sleeve to adjust from a pencil to
F
a fan jet and vice versa.
Detergent nozzle and bottle
Turning the extension lance 4/fan nozzle 12 90°
G
anti-clockwise. Extract the extension lance 4/fan
nozzle 12.
Inserting the detergent-nozzle 7 into the power
H
gun 3. Depress and turn the detergent-nozzle 8 90°
clockwise to lock in place.
Roto nozzle
(red colour coded – AQUATAK 100 PLUS only)
Turn the Jet-fan nozzle 5 anti-clockwise to ex-
I
tract it from the extension lance 4.
Inserting the Roto nozzle 8 into the extension
J
lance 4 and turn the Roto nozzle clockwise until it
"clicks", it is now locked in place.

Starting and Stopping

Starting
Connect the product to the mains supply ensuring
that the mains switch is in the (
Open water tap.
Press the safety lock 1 to release the trigger 2.
K
Fully press the trigger 2 until there is a constant flow
of water to clear the air from the machine and water
supply hose. Release trigger 2. Press the trigger
safety lock.
Press button ( ) on main switch 11.
Point the power gun 3 downwards. Press the trigger
safety lock to release the trigger 2. Fully press the
trigger 2.
Stopping
Release trigger 2. Press the trigger safety lock. The
power gun is now locked and can not be operated
accidentally.
Press button ( ) on the main switch 11.
Close water tap. Unplug the machine from the elec-
tric supply.
Press the trigger safety lock 1 to release the trig-
ger 2. Fully press the trigger 2 until there is no more
water pressure in the machine. Release trigger 2.
Press the trigger safety lock 1.
Disconnect water supply hose from machine and
water supply.
16 • F 016 L70 896 • 12.05
Advice using pressure washer
General
Ensure that the machine is on level ground.
Do not overreach with the high pressure hose or
move the pressure washer by pulling the hose, this
could cause the machine to become unstable and
fall over.
Do not kink or drive a motor vehicle over the high
pressure hose. Do not expose the high pressure
hose to sharp edges or corners.
Never use the roto nozzle to clean motor vehicles.
Operating with Detergents
Only use Bosch approved detergents. Unsuita-
ble detergents may damage the unit and the ob-
ject being cleaned.
Attach the detergent-nozzle to the spray gun.
Fill the detergent bottle with suitable detergent and
screw the bottle back on the detergent-nozzle.
We recommend that you use detergent sparingly for
) position.
the sake of the environment. Observe the re-
commended dilution on the detergent label.
By offering you an individualised range of cleaning
and preserving agents, Bosch guarantees trouble-
free operation of the unit.
Recommended cleaning method
Step 1: Loosening dirt
Spray on detergent sparingly and allow to react for a
short time.
Step 2: Removing dirt
Spray off the loosened dirt with the high-pressure
spray using a jet fan.
Note: When cleaning a vertical surface spray off dirt/
detergent from the bottom and work in an upwards
direction. Rinse from the top and work downwards.
English - 4