Numark AXIS 9 Manual
Cd player with anti-shock
Hide thumbs
Also See for AXIS 9:
- Quick start owner's manual (36 pages) ,
- Reference manual (20 pages) ,
- Reference (7 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Numark AXIS 9
Summary of Contents for Numark AXIS 9
- Page 1 AXIS 2 CD Player with ANTI-SHOCK™ MANUAL ©2001 Industries http://www.numark.com...
-
Page 2: Safety Instructions
Grounding or Polarization - Precautions should be taken so that the grounding or polarization means built into the CD player is not defeated. Internal/External Voltage Selectors - Internal or external voltage selector switches, if any, should only be reset and re-equipped with a proper plug for alternative voltage by a qualified service technician. -
Page 3: Introduction And Registration
PROFESSIONAL TABLETOP CONGRATULATIONS... You have just purchased a CD player designed specifically for the professional DJ. This unit has been designed to provide CD mixing with the same ease and creativity that you have enjoyed with records. Please take a few moments to familiarize yourself with the AXIS 2 by reading the following information before attempting to operate the unit. -
Page 4: Table Of Contents
Matching the Tempo Beat Matching Using Pitch Bend Relay and Fader Start Example of Mixing Before Switching off the Power Troubleshooting Guide Information and Specifications Warranty ©2001 Numark Industries TABLE OF CONTENTS - The Leader in DJ Technology - 4 - http://www.numark.com... -
Page 5: Setup And Connections
5. Connect IEC power cord to appropriate power source. DIGITAL OUTPUTS: This CD player is specially equipped with digital outputs. The format is type 2, form 1, also known as S/PDIF (Sony/Phillips Digital Interface Format). When the digital output is used the variable pitch slider and pitch bend buttons or pitch wheel should not be used. -
Page 6: Top Panel
AXIS 2 TOP PANEL FEATURES - The Leader in DJ Technology ©2001 Numark Industries http://www.numark.com - 6 -... - Page 7 If the units are set to single play mode then relay will alternate after each track. If the unit is set to continuous it will relay after the entire CD is played. ©2001 Numark Industries - The Leader in DJ Technology...
-
Page 8: Front Panel
18. Power Switch- Turn on and turn off the machine with this button. The unit should always be shut down with this button first before any external power is removed. Typically it is recommended that the CD player is powered on before amplifiers and off after amplifiers to avoid an audio spike to be sent through your equipment. -
Page 9: Display
MINUTES - Shows the minutes elapsed or remaining depending on mode setting. SECONDS - Shows the seconds elapsed or remaining depending on mode setting. FRAMES - The CD Player breaks down a second into 75 frames for accurate cueing. This shows the frames elapsed or remaining depending on mode setting. -
Page 10: Play, Pause And Cue Operations
EDITING CUE POINT When the jog wheel is turned while a cue point is set, a new cue point can be located. The CD player will repeatedly play small parts of the CD as you move it to the desired position. By pressing “PLAY/PAUSE” then “CUE” you can confirm that this new cue point is desirable. -
Page 11: Matching The Tempo
Typically if you press the switch once, the attached CD player will activate. When it is pressed again the unit will cue or pause depending upon CD player setting. -
Page 12: Relay And Fader Start
Match the tempo by monitoring the music of both PLAYER 1 and PLAYER 2 by ear and adjusting the pitch. When the tempo of the music of the selected CD player is slow compared to the tempo of the other player, move the slider to the “+”... -
Page 13: Example Of Mixing
PLAYER 2 Press the Pause button of Check you new cue point Listen with the monitor and Do a MIX! With a matching downbeat ©2001 Numark Industries PLAYER 1 OPEN/CLOSE button. PLAYER 2 OPEN/CLOSE button. PLAYER 2 Rapidly search for a cue PLAYER 2. -
Page 14: Before Switching Off The Power
AXIS 2 BEFORE SWITCHING OFF THE POWER: When you have finished using the CD player, be sure that the disc tray is closed with the “OPEN/CLOSE” button before switching off the power. DO NOT switch off the power when the disc holder is open. -
Page 15: Information And Specifications
Weight: Power Supply: Power Consumption: * Specifications are subject to change due to ongoing improvements ©2000 Numark Industries Standard Compact discs (12 cm & 8 cm) Track Elapsed, Track Remain, or Total remain 1 bit linear/Channel, 3 Beam Laser 8 Times 44.1 kHz... -
Page 16: Warranty
Professional Disc Jockey Products What is covered and for how long? NUMARK INDUSTRIES LCC ("NUMARK") warrants to the original purchaser that NUMARK'S DJ Mixers, Amplifiers, CD players, turntables, preamplifiers, beatkeepers, equalizers, microphones, headphones, and all other accessories are free from defects in material and workmanship under normal use and service for the period commencing upon the date of purchase from an authorized NUMARK dealer and continuing for the following period of time after that date for (1) Year.