Wall Mounting (Kx-Tde600/Kx-Tde620) - Panasonic KX-TDE600 Installation Manual

3.2.8 Wall Mounting (KX-TDE600/KX-TDE620)

Mounting Shelves
WARNING
•
Make sure that the wall that the shelf will be attached to is strong enough to support the shelf.
If not, it is necessary for the wall to be reinforced.
•
Only use the wall-mounting equipment (anchor plugs, screws, metal bracket) included with the
PBX.
•
Be careful not to drop any components. Dropping components may damage them or cause an
injury.
CAUTION
•
Do not block the openings of the shelf. Allow space of at least 20 cm above and 10 cm at the sides of
the shelf.
•
Make sure that the surface behind the shelf is flat and free of obstacles, so that the openings on the
back of the shelf will not be blocked.
•
Make sure that the surface behind the shelf is not made of wood.
Notice
•
When placing the metal bracket, make sure that the "TOP" arrow is pointing upward.
•
When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths or metal
plates in the wall.
•
When this product is no longer in use, make sure to detach it from the wall.
Note
•
Make sure to remove the front cover from each shelf before installing the shelves (refer
to "3.2.3 Opening/Closing the Front Cover").
•
Do not install any optional service cards or a PSU in the shelves before installation.
•
For details about the dimensions and weight of the PBX, refer to "1.3.1 General Description".
3.2.8 Wall Mounting (KX-TDE600/KX-TDE620)
Installation Manual 107