Advertisement
Table of Contents
- 1 Safety Precautions
- 2 Use of Extension Cords
- 3 Parts & Assembly
- 4 Accessories List
- 5 Installing Co2 Regulator/Cylinder
- 6 Installing the Casters
- 7 Installing the Beer Tap
- 8 Installing the Guardrail
- 9 Tapping the Beer Keg
- 10 Cleaning and Maintenance
- 11 Storage & Care
- 12 Customer Service
- Download this manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Nostalgia Electrics KEGORATOR KRS-2000 SERIES
Summary of Contents for Nostalgia Electrics KEGORATOR KRS-2000 SERIES
- Page 1 Nostalgia Products Group, LLC 1471 Partnership Dr. Green Bay, WI 54303-5685 Visit us online at www.nostalgiaelectrics.com ©2009 Nostalgia Products Group LLC Rev. 8/18/09...
- Page 2 KEGORATOR™ KRS-2000 SERIES INSTRUCTION MANUAL FOR HOUSEHOLD USE ONLY READ THESE INSTRUCTIONS BEFORE USING THIS UNIT! SAVE THESE INSTRUCTIONS!
-
Page 3: Safety Precautions
Safety Precautions Read all of the instructions before using this appliance. When using this appliance, always exercise basic safety precautions, including the following: Use this appliance only for its intended purpose as described in this operation manual. This appliance must be properly installed in accordance with the installation instructions before it is used. - Page 4 Never attempt to refill CO 2 cylinder yourself. CO 2 tanks can be refilled at locations such as welding supply shops, party stores, or wherever kegs are purchased. NOTE: If the refrigerator has been placed in a horizontal or tilted position for any period of time wait 24 hours before plugging the unit in.
-
Page 5: Use Of Extension Cords
Introduction • To ensure that your KEGORATOR™ works to the maximum efficiency it was designed for, keep it in a location where there is proper air circulation and electrical outlets. • Choose a location where the KEGORATOR™ will be away from heat and will not be exposed to direct sunlight. • This KEGORATOR™ is designed for indoor use only -- it should not be used outdoors. -
Page 6: Parts & Assembly
Parts & Assembly Read assembly instructions carefully to ensure that you understand all installation instructions before installing the KEGORATOR™. If after completing the process you are still unsure whether the KEGORATOR™ has been properly installed, we recommend that you contact a qualified installer. Note: Allow the KEGORATOR™ to stand in an upright position for about 8 hours before turning on the power. - Page 7 Regulator The regulator works the Co2 Tank Valve and measures PSI (pounds per square inch), as well as the volume of the Co2 gas in the Cylinder. Output Pressure Gauge (0-60 PSI) for measuring PSI of CO 2 in tank. Tank Pressure Gauge (0-3000 PSI) for measuring PSI of CO 2 outflow from...
-
Page 8: Installing Co2 Regulator/Cylinder
Installing the CO2 Regulator and the CO2 Cylinder Follow these steps to safely install the CO 2 regulator and CO 2 cylinder. You must read and understand the following procedures for the CO 2 cylinders before installation. NOTE: If all your rubber washers & O-rings are not pre-installed, please refer to your parts list (pg. - Page 9 O-ring for tap STEP 7 After the tap tower has been placed on the refrigerator and the hose line feeds through the bottom, attach the wing nut to the coupler. O-rings on the CO 2 line O-ring for coupler...
-
Page 10: Installing The Casters
Note: Keep this plug in a safe place -- it will be required when using the KEGORATOR™ as a refrigerator without a beer keg in use. There are notches on the bottom of the draft arm... -
Page 11: Tapping The Beer Keg
Tapping the Beer Keg (Single-Valve Type Barrel) Follow these steps below to tap the beer keg. Make sure the black pull handle of the coupler is in the closed (up) position before installing it on the keg (Fig. 1 - below). Insert the keg coupler into the locking neck of the beer keg and turn clockwise until it locks into position (Fig. -
Page 12: Cleaning And Maintenance
Operating Your KEGORATOR™ Dispensing Beer Follow the steps below to dispense beer. Make sure that the KEGORATOR™ is plugged in properly to a 120V, 60Hz, 15Amps grounded AC outlet. Place the drip tray under the beer faucet to avoid messes from excess beer. Open the beer faucet by pulling the tap towards you to dispense the beer. -
Page 13: Customer Service
Customer Service Inquiry form and click the Submit button. A representative will contact you as soon as possible. KEGORATOR™ KRS-2000 Series Limited Warranty This appliance is designed and built to provide many years of satisfactory performance under normal household use. The distributor pledges to the original owner that should there be any defects in material or workmanship during the first 90 days of purchase, we will repair or replace the unit at our option.
Need help?
Do you have a question about the KEGORATOR KRS-2000 SERIES and is the answer not in the manual?
Questions and answers