Brother MFC-J6910DW User Manual page 104

Error Message
DR Mode in Use
High Temperature
Hub is Unusable.
Image Too Long.
Image Too Small.
Ink Absorber Full
Downloaded from ManualsPrinter.com Manuals
Cause
The machine is set to Distinctive Ring
mode. You cannot change the
Receive Mode from Manual to another
mode.
The print head is too warm.
A Hub or USB Flash memory drive
with Hub has been connected to the
USB direct interface.
The proportions of your photo are
irregular so effects could not be
added.
The size of your photo is too small to
trim.
The ink absorber box or flushing box is
full. These components are periodic
maintenance items that may require
replacement after a period of time to
ensure optimum performance from
your Brother machine. The need to
replace these items and the time
period before replacement is
dependent on the number of purges
and flushes required to clean the ink
system. These boxes acquire
amounts of ink during the different
purging and flushing operations. The
number of times a machine purges
and flushes for cleaning varies
depending on different situations. For
example, frequently powering the
machine on and off will cause
numerous cleaning cycles since the
machine automatically cleans upon
power up. The use of non-Brother ink
may cause frequent cleanings
because non-Brother ink could cause
poor print quality which is resolved by
cleaning. The more cleaning the
machine requires the faster these
boxes will fill up.
Note
Repairs resulting from the use of
non-Brother supplies may not be
covered under the stated product
warranty.
Troubleshooting
Action
Set Distinctive Ring to Off. (See
Turning off Distinctive Ring
on page 44.)
Allow the machine to cool down.
A Hub or USB Flash memory drive
with Hub are not supported. Unplug
the device from the USB direct
interface.
Choose a regularly proportioned
image.
Choose a larger image.
The ink absorber box or flushing box
will need to be replaced. Contact
Brother Customer Service or a Brother
Authorized Service Center to have
your machine serviced. (See Brother
numbers on page i.)
Other reasons for cleaning are:
1 Machine automatically cleans after
clearing a printer jam.
2 Machine automatically cleans after
sitting idle for more than 45 days
(infrequent use).
B
73