Brother DCP-J125 User Manual page 81

Error Message
BT Call Sign On
(U.K. only)
Cannot Detect
Cannot Print
Replace Ink
Comm.Error
Cover is Open
Data Remaining
Disconnected
Document Jam
High Temperature
58
Downloaded from ManualsPrinter.com Manuals
Cause
BT Call Sign is set to ON. You
cannot change the Receive Mode
from Manual to another mode.
You installed a new ink cartridge
too quickly and the machine did
not detect it.
If you are using non Brother
Original ink the machine may not
detect the ink cartridge.
An ink cartridge is not installed
correctly.
One or more of the ink cartridges
have reached the end of their life.
The machine will stop all print
operations. While memory is
available, monochrome faxes will
be stored in the memory. If a
sending machine has a colour fax,
the machine's "handshake" will
ask that the fax be sent as
monochrome.
Poor telephone line quality
caused a communication error.
The scanner cover is not
completely closed.
The ink cartridge cover is not
completely closed.
Print data is left in the machine's
memory.
The other person or other
person's fax machine stopped the
call.
The document was not inserted or
fed correctly, or the document
scanned from the ADF was too
long.
The print head is too warm.
Action
Set BT Call Sign to OFF. (See BT Call Sign
(U.K. only) in chapter 5 in the Advanced
User's Guide.)
Take out the new ink cartridge and
re-install it slowly until it clicks.
Replace the cartridge with a Brother
Original ink cartridge. If the error message
remains, contact your Brother dealer.
Take out the new ink cartridge and re-
install it slowly until it clicks. (See
Replacing the ink cartridges on page 51.)
Replace the ink cartridges. (See Replacing
the ink cartridges on page 51.)
If the problem continues, call the telephone
company and ask them to check your
telephone line.
Lift the scanner cover and then close it
again.
Firmly close the ink cartridge cover until it
clicks.
Press Stop/Exit. The machine will cancel
the job and clear it from the memory. Try to
print again.
Try to send or receive again.
(See Using the ADF (MFC-J410 and
MFC-J415W only) on page 20.)
(See Document jam (MFC-J410 and
MFC-J415W only) on page 62.)
Allow the machine to cool down.