Com Port; Rj-45 Ethernet Port - Bosch DVA-08E Quick Installation Manual

80 en | Subsystem Cable Connections
DVA-08K
Figure 7.4 Controller Module DVA-08K
DVA-16K
Figure 7.5 Controller Module DVA-16K
2.
3.
NOTICE!
DVA-08E cannot be cascaded.
7.3

COM Port

The DVA-08E and DVA-08K comes with one (1) COM port and the DVA-16K with two (2) COM
ports. The COM1 port is reserved for terminal emulation management. This port can be used
to access firmware's embedded configuration utility. One (1) audio-jack to DB9 cable and a
null modem adapter are provided to facilitate the connection of the COM1 port. (See
Figure 7.3, Figure 7.4, and Figure 7.5)
The COM2 port of DVA-16K is reserved. Do not use!
7.4

RJ-45 Ethernet Port

A shielded Ethernet cable can be used to connect the RJ-45 Ethernet port to a hub on a
network, enabling you to manage your subsystem via the network. (See Figure 7.3, Figure 7.4,
and Figure 7.5)
F.01U.027.800 | V5 | 2010.06
Attach the VHDCI SCSI connector to the subsystem and attach the other end to the host
computer or DVR. Note that the subsystem comes with a firmware terminator and
requires no additional terminators on the subsystem side.
If two subsystems are cascaded, disable the firmware terminator setting on the
subsystem which is connected in between the host and another subsystem (see
Section 12 Connecting a Digital Video Recorder).
Quick Installation Guide
RAID Subsystem DVA-08E, -08K, -16K
Bosch Sicherheitssysteme GmbH