Installation Procedures; Unpacking The Subsystem; Rack Mounting - Bosch DVA-08E Quick Installation Manual

RAID Subsystem DVA-08E, -08K, -16K
3

Installation Procedures

To install the subsystem use the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
4

Unpacking the Subsystem

Check the included Unpacking Checklist and verify the model name and shipping contents
against the checklist.
5

Rack Mounting

Slide rails are required for rack mounting. For rack mounting use only one of the following
slide rail kits:
DVA-ASRK-28A
Slide rails for 647 mm to
914 mm deep racks
(25.5" to 36")
Slide rails for 610 mm to
813 mm deep rack
(24" to 32")
Slide rails for 660 mm to
914 mm deep rack
(26" to 36")
Table 5.1 Slide rail kits
NOTICE!
Refer to Slide Rail Kit Installation Manual for detailed information.
Bosch Sicherheitssysteme GmbH
Unpack the Subsystem (see Section 4 Unpacking the Subsystem)
Install the system in the rack (see Section 5 Rack Mounting)
Install the Drive Tray (see Section 6 Drive Tray Installation)
Connect the Subsystem Cable (see Section 7 Subsystem Cable Connections)
Power On (see Section 8 Power On)
Configure the Host Computer (see Section 9 Configuring the Host Computer via a Network)
Change the IP Address (see Section 10 Changing the Configuration via a Web Browser)
Change the factory default settings (see Section 10.2 Guidelines for Setting up a RAID)
Connect the DVR (see Section 12 Connecting a Digital Video Recorder)
DVA-08E and DVA-08K
Slide rails for 533 mm to
724 mm deep racks
(21" to 28.5")
DVA-ASRK-36A
--
--
Quick Installation Guide
Installation Procedures | en
DVA-16K
--
--
DVA-ASK-32A
DVA-ASK-35A
F.01U.027.800 | V5 | 2010.06
77