Wall Mounting (Kx-Tde100) - Panasonic KX-TDE100 Installation Manual

3.2.11 Wall Mounting (KX-TDE100)

3.2.11 Wall Mounting (KX-TDE100)
WARNING
•
Make sure that the wall that the shelf will be attached to is strong enough to support the shelf.
If not, it is necessary for the wall to be reinforced.
•
Only use the wall-mounting equipment (anchor plugs, screws, metal bracket) included with the
PBX.
•
Be careful not to drop any components. Dropping components may damage them or cause an
injury.
CAUTION
•
Do not block the openings of the shelf. Allow space of at least 20 cm (8 in) above and 10 cm (4 in) at
the sides of the shelf.
•
Make sure that the surface behind the shelf is flat and free of obstacles, so that the openings on the
back of the shelf will not be blocked.
•
Make sure that the surface behind the shelf is not made of wood.
•
When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths or metal
plates in the wall.
•
When this product is no longer in use, make sure to detach it from the wall.
Notice
When placing the metal bracket, make sure that the "TOP" arrow is pointing upward.
Note
•
Make sure to remove the front cover from each shelf before installing the shelves (refer to
"3.2.3 Opening/Closing the Front Cover").
•
Do not install any optional service cards or a PSU in the shelves before installation.
•
For details about the dimensions and weight of the PBX, refer to "1.3.1 General Description."
70 Installation Manual Document Version 2010-08