Canon MX490 series Online Manual page 796

5. Perform setup with the Setup CD-ROM or perform it according to the instructions on our website.
Cannot Communicate with the Machine while It Is in the Access Point
Mode
Make sure that the machine is turned on.
Check1
Is Change LAN in LAN settings under Device settings set to LAN inactive
Check2
or Wireless LAN?
Select Access point mode.
Have you selected the machine as the destination of your external
Check3
communication devices (e.g. computers, smartphones, or tablets)?
Select the access point name (SSID) of the machine with your external communication devices.
Have you entered the proper password specified for the access point mode?
Check4
If the security setting of the access point mode is enabled, you need to enter the password to connect your
external communication device to the machine. Confirm the specified password, then enter the proper one.
Make sure that external communication devices are not placed far away from
Check5
the machine.
Locate your external communication device close enough to communicate with the machine.
Make sure that there is no obstruction.
Check6
Wireless communication between different rooms or floors is generally poor. Adjust the location of the devices.
Make sure that there is no source of radio wave interference in your vicinity.
Check7
If a device (e.g. microwave oven) using the same frequency bandwidth as the wireless station is placed
nearby, the device may cause interference. Place the wireless station as far away from the interference source
as possible.
Are you trying to connect 6 devices or more?
Check8
You can connect up to 5 devices using the access point mode.
Cannot Print, Scan, or Fax from a Computer Connected to the
Network
Make sure that the network settings of the computer are correct.
Check1
Downloaded from ManualsPrinter.com Manuals 796