Canon MX490 series Online Manual page 222

Printing/Scanning with the Access Point Mode
Print/Scan with the access point mode following the procedure below.
1. Connect an external device such as a computer or a smartphone to the machine via
wireless LAN.
Perform wireless LAN settings with your external device, then assign the access point name (SSID)
specified for the machine as a destination.
Note
• For details on how to perform wireless LAN settings with an external device, refer to the
device's instruction manual.
• When a WPA2-PSK (AES) password is valid on the machine, entering the password is required
to connect an external device to the machine via wireless LAN. Enter the password specified for
the machine.
2. Start printing or scanning from an external device such as a computer or a smartphone.
Note
• For details on how to print or scan from an external device such as a computer or a smartphone
via wireless LAN, refer to the device's or application's instruction manual.
How to terminate the Access Point Mode
In environments that the machine is usually connected with the computer over the wireless LAN, set the
machine to the wireless LAN connection following the procedure below when you finish using the machine
with the access point mode temporarily.
1. Press the Setup button.
The Setup menu screen is displayed.
2. Use the
The Device settings screen is displayed.
3. Use the
4. Use the
5. Use the
If you do not use the machine over wireless LAN, select LAN inactive.
Setting of the Access Point Mode
Specify the settings for the access point mode following the procedure below.
1. Make sure that the machine is turned on.
Downloaded from ManualsPrinter.com Manuals
button to select Device settings, then press the OK button.
button to select LAN settings, then press the OK button.
button to select Change LAN, then press the OK button.
button to select Wireless LAN, then press the OK button.
222