Table of Contents
Advertisement
Value
0
No designated data forwarding character
2
Data forwarding on carriage return *
126
Data forwarding on all ASCII decimal characters from 0 to 31 and
character DEL. (Refer to Appendix F)
*default
Parameter 4: Selection of Idle Timer Delay
Value
0
No idle timer delay *
1 to 255
Specifies the timer value in 20ths of a second
*default
Table 12-9: Data Forwarding Character
Description
If a data forwarding character's function is duplicated, the
associated function for the character is according to following
priority:
1. PAD recall
2. Command signal delimiter
3. XON and XOFF
4. Line display
5. Character delete
6. Line delete
7. Data forwarding
For example, if the character DLE is assigned to two functions
data forwarding (parameter 3 = 126) and PAD recall
(parameter 1 = 1), DLE is treated as the PAD recall character.
The PAD recall function has higher priority than the data
forwarding function. This also applies to: BS, CAN, DC1,
DC2, DC3, and DC4 (refer to Appendix F).
This parameter designates the amount of idle time (time in
which a character is not received) allowed after the PAD has
received a character from the local DTE device before the
entire PAD buffer is forwarded. The idle timer is not started if
parameter 15 is enabled. The decimal value stored in parameter
4 designates the timer value in 20ths of a second.
Table 12-10: Idle Timer Delay
Description
UTA220/UTA220k
D-Channel X.25
12-21
Advertisement
Table of Contents
