Table of Contents
Advertisement
D-Channel X.25
Value
0
Page wait disabled *
1 to 255
Maximum page wait line feed character count. After this specified
number of line feeds, the PAD suspends transmission of data to the
local DTE and the PAD transmits the PAGE service signals. For
display terminals, a page wait line feed count of 23 is commonly used.
*default
12-34
Note: If parameter 6 (control of PAD service signals) is set to
0 (no PAD service signals) and parameter 22 (page wait) is
enabled, the page wait service signal will not be transmitted
to the local DTE. However, when the number of line feeds
specified in parameter 22 transmitting data to the local DTE
anyway. To resume the transmission of data, an XON must be
transmitted to the PAD by the user, or any of the above page
wait cancellation conditions must occur.
Table 12-28: Page Wait
Description
UTA220/UTA220k
Advertisement
Table of Contents
