Care And Cleaning; Self Clean Feature; Shot Of Steam - Breville 2400W Manual

Shot of steam

Press the shot of steam button
extra steam. Steam will burst from the holes in the soleplate of your iron into the fabric.
The temperature control
several seconds between each press of the steam button.
Spray feature
The water spray can be used to help iron heavy fabrics or difficult areas (collars,
pockets, sleeves, creases, etc). It can also be used when ironing delicate fabrics which
cannot be steam ironed.
Make sure there is water in the tank. Press the spray button
water.

Care and cleaning

Warning: Do not use harsh abrasives, chemical cleaners or solvents to clean the
exterior of your iron.
Allow your iron to completely cool down and wipe the soleplate with a soft damp cloth. If
polyester has burnt to the soleplate, iron a damp cotton cloth while your iron is still hot.
Wipe over the rest of your iron with a soft damp cloth then wipe dry.

Self clean feature

Use the self-clean function once every two weeks. If the water in your area is very hard,
the self clean function should be used more frequently.
1. Unplug your iron then set the steam control
2. Fill your iron with water to the MAX mark.
3. Plug your iron in then set the temperature control
Allow your iron to heat up until the temperature indicator light
4. Unplug your iron and hold it over a sink with the soleplate facing downwards.
5. Press and hold the self-clean button
the holes in the soleplate along with any impurities.
6. Release the self-clean button after one minute or when the water tank is empty.
7. Iron an old piece of cloth to allow any remaining water to escape.
8. After use, unplug your iron and allow it to fully cool. Empty out any remaining
water.
Cleaning the steam holes
Use a cotton wool tip moistened with methylated spirits. Wipe off the methylated spirits
with a damp cloth then dry the soleplate.
Storing
Warning: Allow your iron to completely cool before storing. Always store your iron
on its heel rest. Do not store your iron resting on its soleplate.
Never wrap the power cord around the soleplate. The cord can be neatly wrapped
around the heel of your iron.
whenever you have a stubborn crease that needs
e
must be set within the
y
s
and
ll lll
r
to the no steam position (0).
w
to the highest (MAX) setting.
y
. Hot water and steam will be ejected from
setting. Wait
to produce a spray of
comes on.
t
5