Sony CDP-CX90ES Service Manual page 24

QQ
3 7 63 1515 0
SENSOR ALIGNMENT
Perform this adjustment after the "holder (disc A) adjustment".
If the disc table swings to the left and right just before the disc is
chucked, perform the following adjustment.
Cam
(1)Rotate the cam and adjust to the position
shown in the figure.
(2)Check that the lever (stopper) assem-
bly secures the disc table as shown in
the figure.
TE
L 13942296513
Lever (stopper) assembly
Tapering screwdriver
Luminus board
Bracket (sensor)
www
(3)Loosen the fixed screw by 60° to 90°, and use a tapering screwdriver to adjust the screw as shown in the figure.
Move the bracket (sensor) with the tapering screwdriver little by little, and fix the fixed screw at where the play button's LED (green) is
.
switched to the pause button's LED (orange) (or its reverse).
http://www.xiaoyu163.com
Bracket (sensor)
Disc table
Fixed screw
x ao u163
y
i
— 24 —
http://www.xiaoyu163.com
2 9
8
Cam
Table assembly
Q Q
3 6 7 1 3 1 5
(4)Moving the disc table right and left with a hand after the screw is
fixed, the table will move by the play of a disc table. If the LEDs
light up alternately, the adjustment will be performed correctly.
PLAY button
co
.
9 4 2 8
LEVER (stopper)
assembly
0 5 8 2 9 9 4 2 8
Swing
PAUSE button
m
9 9
9 9