Download  Print this page

Carburetor Separation; Carburetor Joining - Kawasaki ZR-7S Service Manual

Hide thumbs

Advertisement

2-18 FUEL SYSTEM
Carburetors
.
For the other than U.S.A., Canada and Taiwan .model:
apply heat transfer grease, and install the sensor [A] and
the heater [8] into the carburetor.
.Install the sensor lead, and tighten the plate [C] and the
clamp [0] with screw [E].
Carburetor
Separation
. Remove the carburetor (see Carburetor Removal).
.
Read the WARNING in the carburetor disassembly.
.
Mark carburetor locations so that the carburetors can be
installed in their original positions.
.
Disconnect the pipe and lead, leaving them connected to
either side.
.
Remove:
Choke lever Plate [A]
Cylinder Side Connecting Plate [8]
.
Remove:
Air Cleaner Side Connecting Plate [A]
.
Separate the carburetor.
Carburetor Joining
.
The center lines of the carburetor bores must be parallel
both horizontally and vertically. If they are not, loosen
the mounting screws and align the carburetors on a flat
surface.
.
Retighten the mounting screws.
.
After installing the choke mechanism, check to see that
the starter plunger lever [A] slides right to left [8] smoothly
without abnormal friction.
CAUTION
Fuel mixture trouble could result if the starter
plunger does not seat properly in its rest position
after the choke lever is returned.

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: