Download  Print this page

Advertisement

2-16 FUEL SYSTEM
Carburetors
.
For the other than U.S.A., Canada and Taiwan model:
remove the screws [A], disconnect the carburetor tem-
perature sensor connector [8] and take off the carburetor
heater lead [C] together with the clamps [D], heater hold-
ers [E] and heaters.
ORemove the temperature sensor, if necessary.
OPinch the stopper [A] and then pull the clamp [8].
ODisconnect the connector [C] of the carburetor heater [D].
Carburetor Heater Holder [E]
.
Do not remove the pilot screw [A] if possible (see Pilot
Screw Adjustment).
.
Remove the float bowl screws [8], the float bowl [C], and
the O-ring.
.
Remove the float pivot pin [A], and remove the float [8].
The float needle valve comes out together (see Service
Fuel Level Adjustment).
.
Remove the pilot jet [C].
.
Remove the main jet [D].
.
Remove the needle jet holder [E].
.
Push the needle jet [A] down from the carburetor bore.

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: