Download  Print this page

Fuel System Cleaning And Inspection; Carburetor Removal - Kawasaki ZR-7S Service Manual

Hide thumbs

Advertisement

Carburetors
FUEL SYSTEM 2-13
NOTE
000 not press on the needle rod [A} when measuring the
float height [B}.
.
Assemble the carburetor and recheck the fuel level.
*If the fuel level cannot be adjusted by this method, the
float or the float valve [C] is damaged.
Fuel System Cleaning and Inspection
A
WARNING
Gasoline is extremely flammable and can be ex-
plosive under certain conditions. Turn the ignition
switch OFF. Do not smoke. Make sure the area is
well-ventilated and free form any source of flame
or sparks; this includes any appliance with a pilot
light.
.
Connect
a suitable hose to the fitting at the bottom of each
carburetor float bowl and run their lower ends into a suit-
able container.
.
Turn the fuel tap to the PRI position.
.
Turn out the carburetor drain bolt [A] and check to see if
water or dirt comes out.
Special Tool
-
Carburetor
Drain
Plug
Wrench,
Hex 3:
57001-1269
*If any water or dirt appears during the above inspection,
clean the carburetors and the fuel tank.
Carburetor
Removal
A
WARNING
Gasoline is extremely flammable and can be ex-
plosive under certain conditions. Turn the ignition
switch OFF. Do not smoke. Make sure the area is
well-ventilated and free form any source of flame
or sparks; this includes any appliance with a pilot
light.
.
Remove:
Seats (see Frame chapter)
Fuel Tank (see Fuel Tank Removal)
Vent Hose [A] (Clear the Vacuum Valve Switch Hose)
Vacuum Hose (For the California and Taiwan Model) [8]
Vacuum Hose [C]
Throttle Sensor Connector [D]
Carburetor
Heater
Connectors
(For the other than
U.S.A., Canada and Taiwan Model)
Carburetor Clamp Screws [E]
Holder Spring [F]
Choke Cable End [G]
GC060167S1
C

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: