2-8 FUEL SYSTEM
Throttle Grip and Cables
Throttle Cable Installation
the throttle cables in accordance with the Cable,
Wire, and Hose Routing section in the Generallnforma-
Install the lower ends of the throttle cables in the bracket
on the carburetor after installing the upper ends of the
throttle cable in the grip.
After installation, adjust each cable properly.
Operation with incorrectly routed or improperly ad-
justed cables could result in an unsafe riding con-
Throttle Cable Lubrication and Inspection
the cables are removed, or in accordance with
the Periodic Maintenance Chart, lubricate the throttle ca-
bles (see General Lubrication in the Appendix chapter).
Apply a thin coating of grease to the cable upper ends.
. Use a commercially available pressure cable lubricator to
lubricate the cables.
With the cable disconnected at both ends, the cable
should move freely in the cable housing.